Micro powder mill specifications Operating Instructions

When using micro powder mill,you should pay attention proper operation, so you can ensure the safety of the operator, you can also extend the life of the machine makes, Clirik to tell you the micro powder mill standard operating instructions.

First  before the micro powder mill start running,you should inspection each part  good mechanical and electrical equipment, check the connecting bolts are loose; whether all lubrication points lubrication is normal, if normal and reliable transmission, guards intact, electrical instruments are sensitive, good contact brushless motor Wait;

 

Second the disk drive week inspection equipment rotating part or around obstructions, and eliminated. When you start the surrounding people can not stand;

 

Third After the check, press the start button to start the motor, pay attention to current changes. micro powder mill no more than two consecutive start, the first and second every 5 minutes or more, if the third starter, must be followed by electricians, fitters with the check with before they start. Not with other devices in the same play, staggered start to avoid tripping;

 

Fourth Micro powder mill normal operation, in strict accordance with the water supply to the mine, a given ball prohibiting overload, idle time is not more than 15 minutes, so as not to bash liner;

 

Fifth pay attention to check the operation of the cylinder for leaks pulp, carefully observe current, voltage, feed, water supply is normal, check once every half-hour motor and spindle temperature not higher than 60 ° С, identify problems and timely treatment;

 

Sixth the operation to observe the hollow shaft, whether the oil ring is rotated with oil, the hollow shaft temperature is normal, if found hollow shaft fever, approaching bush-burning should take immediate forced cooling measures may not stop immediately, so as to avoid "axle . " Also note that check the lubrication oil, temperature, time refueling;

 

Seventh Micro powder mill parking should be preceded by stop to the mining, ore processing after the internal standby, stop water supply. Press stop button, pull down the gates;

 

Eigth in the absence of notification power outage, the first pull down the knife, press the stop button to stop for mechanical processing ore, add water;

 

Ninth After closing the micro powder mill equipment must remember to clean machinery.

 

Shanghai Clirik is specialized in producing milling machine manufacturers, the production of mill equipment, the price is the highest price in the same industry suppliers! We are also responsible for the entire micro powder mill equipment design, manufacture, installation guide, commissioning and technical services, welcome customers to visit.